If you have a Manfrotto Magic Arm

B_PB2362

If you have a Manfrotto Magic Arm and it makes a horrible clunk & or grinding noise when you lock it in place then you have a problem, not an insolvable one, but a bit fiddly.

The problem seems to be a bearing that jumps out of its runner so it needs to be put back in its place.

You will need an allen key, you may need some grease as well,  if it has been doing it a while there may be bits of ball bearing floating around, so you may also need a replacement bearing set. Which are available from our friends  Manfrotto Spares in Dunsfold .

B_PB2370

Firstly loosen off the silver allen bolt a couple of turns, this will free up the locking handle end so that the handle can be removed by unscrewing it. Make sure that you keep the assembly together in your hands as you will otherwise be hunting for the 9 ball bearings on the floor. Once the handle has been removed you will see the three seats for the bearings.

B_PB2368

Simply place one bearing in each seat, and re-assemble, takes all of 5 minutes. Job done, no more grinding.

Good luck , as with most things, Don’t try it if you are not confident that you can manage it, as I shall not be answering individual requests for help (probably), and don’t try it if you are in the warranty period, also accept no responsibility for you getting bearings stuck up your nose or any other orifice.

 

 

Advertisements

Leave a Reply

Fill in your details below or click an icon to log in:

WordPress.com Logo

You are commenting using your WordPress.com account. Log Out /  Change )

Google photo

You are commenting using your Google account. Log Out /  Change )

Twitter picture

You are commenting using your Twitter account. Log Out /  Change )

Facebook photo

You are commenting using your Facebook account. Log Out /  Change )

Connecting to %s